Htanch SG538(13-Pack) SG506 for Weber Genesis I - IV and Weber Genesis 1000, 5500 Genesis 1300, Genesis 2000, Genesis 2300, Genesis 3300, Genesis 3500,5000 Platinum I & II for Weber 7538 Weber 7506

Fit like the factory and disperse the heat better

Doesn't fit quite right. Looks like it first at first, but once you start using it, the right burner pops out, and leaves a heavy flame at the end of the tube only.

Product is great with regard to fit and function, however my package arrived with only 7 of the 8 shorter flavor bars.

Good product, especially the flavorizer bars. They are much heavier than ones I’ve purchased in the past. The burner tubes are OK except for being too tight where the igniter fits. Tried to open it up a little and the steel started to crack. Still held but much more and it would break off. Be careful!

Works well. My only issue is that it seems to allow more gas through which the regulator doesn’t exactly keep up with, this makes the hot/cool spots on the grill more uneven.

Arrived today on schedule. From box to grill in less than 5 minutes! Perfect fit! First, if you get these, note that they are 21.5 inches and NOT 22.5 inches. Last replaced these in 2015 with Weber OMP so I can't really complain as I used my grill quite a bit all year long and got 7 years out of them. Was going to purchase the same set of flavor bars for $58.49 but after speaking with someone here locally was told the quality has gone downhill. Ordered these instead for $25.99 and I have to tell you, I think they look better and are heavier than the OMP I purchased in 2015. Makes the old girll look like brand new! It may be 10 degrees & snowing like crazy today here in Rochester, NY, but I'm heading to Wegmans right now so we can be grilling tonight!

Thick stainless steel but they didn't fit in my Genesis Silver A until I did a little reworking with my bench vise. Didn't take much time and afterwards they fit and look great but if you don't have a vise I think you'd be up a creek.

If your flavorizer bars and gas tubes were as corroded as mine, then this is the kit to purchase. I was a little hessitant at first, but went with my instinct. I'm glad I did, as the cost of this entire kit was cheaper than just the flavorizers from Weber. And, in fact I couldn't even FIND the replacement gas tubes from Weber direct so good job!The installation was very easy. I took off the 3 burner knobs, the 3 screws that keep the tubes in position at the back of the BBQ. Then there are two screws each side on the front control deck, remove those. Then there are two 12mm bolts approx between the 3 burners remove those. Lift the control panel upwards, then gently move to the right and disconnect the igniter from the first gas tube. Remove all 3 gas lines and the connecting tube at the back. Put in your new lines and reverse the procedure. All up, i was back on the gas within 20 minutes. My BBQ now ignites the middle and right tube a lot faster than before also.100% satisfied, thank you!