CZC AUTO Trailer Wiring Harness Kit 4-Way Wishbone Style Y Style 18AWG Pure Copper Core Color Coded Wire with Standard 4-pin Flat Plug Connector, 4' Female and 25' Male for 12V Trailer Boat

The wire was ease to put on . And the lights work just fine.

After a lengthly installion came the BIG TEST. Left running light failed. Faulty connection inside plug. Recommend testing harness before installation.

Decent solid copper wire and plenty of length in the harness.My only negative is that the white ground wire wasn’t long enough. I left it full length it came with and terminated it with a ring terminal and grounding screw at the front of the A-frame. The first left turn of the trailer pulled the pin connector off the car because it wasn’t long enough.Other than that, it worked well and there were no issues. I would buy this again, unless there was an option that included marine grade wire or a slightly larger gauge, but these are not necessary.

Purchased to rewire my small trailer. Didn't need it that long but can use extra wire for another project.

I bought this kit because it is the “Y” or wishbone design meaning that the wires for the lights splits at the hitch and travel on each side of the trailer. It was wired differently from the factory with the wire running only along one side. Because of this I had to drill holes in the frame where there had been no wires before but I still liked this design better. I used it in a 5 x 12 trailer and I had more than enough wire length. Keep in mind that you may need rubber grommets when installing on the trailer as well as electrical tape.

I was replacing existing wiring, so it was really easy to do. Came with 4 vampire taps and a handful of clips. I had to reuse a few of my older clips; it would be great if it came with twice as many.Note that the trailer end's ground wire is obnoxiously short. Can't comment on the vehicle end of the harness; I didn't need it.

I got this to fix a friends boat trailer, after installing it the right tail light wouldnt work, left side was fine and stop and turn worker fine. I pulled the wire as far out of the tongue as I could and stripped both brown wires left had power right didn't. I twisted and soldered the wires together and wrapped with tape and then slid it back into the tongue. QC is obviously 0, I bought this one since the clips came with it, required 6 to get 3 to work, they just broke pushing them onto the frame rail

Great inexpensive but sturdy wiring kit with clips and connectors. I tossed the connectors opting for water proof heat shrink butt connectors.

Perfect for replacement !

I needed to completely rewire my trailer, and this was perfect. More than enough wire to do the job, and came with clips as well to hold the wires safely. I'm very pleased with this product and would order again!

Well made good quality

bon produit

Plenty of wire for my snowmobile trailer. Did not use the cheap connectors, went with heat shrink butt connectors