New Replacement Scooter Handle Grips for Razor Scooters (Black)

Easy to install and work perfectly.

The "lips" of the grips are smaller than my original, so the plastic disc things that cap off the handle tubes poke out beyond the grips. They otherwise work awesome! The hairspray tip in their instructions worked wonders.

Bought these to replace the foam handlebar grips on my son's Razor scooter. Looks and feels almost the same as the originals. Easy to install.Here is how I replaced the old grips:1. Pull one end cap off the handlebar and undo knot or cut elastic cord close to knot2. Cut old grips off with scissors3. Spray hair spray inside new grips and on the handlebars4. Slide new grips on5. Thread cord back through handlebars and retie to the second end cap

Difficult to put on, but they work great.

So I read the reviews and went ahead and purchased. The product arrived in the advertised time and I grabbed a can of my wife's hairspray as instructed by the typo riddled instructions for installation. The first grip went on fairly smoothly. The inside diameter of the grip is slightly smaller that the original grips, so it took a little twisting and pushing to get it on. It slid on after a fashion, so I started the second grip. This is where the things got dicey. The grip slid on about halfway, then promptly split about a quarter of the way down the grip. This was most unfortunate as the scooter on to which these grips were being installed was a gift. Now it has one black and one red grip, Though my son will probably never notice, or care, that is five bucks out of my pocket for a useless product. I ordered a slightly more expensive pair for the next go round. Let's hope they stand up a bit better.

This works perfect for the razor scooters. I used a little Pam to make it easier to slip them on. Looks brand new again.

Just as advertised - only caveat, be sure to have hairspray to install. Then, they are easy have been great.

Holes are too small to fit onto standard Razor handlebars. Do not buy.