HYSCar Antenna Mount Stainless Steel Car Clip Mount Trunk Lid Hatchback Mount Bracket Adjustable Angle with SO239 to PL-259 Connector,16.4Ft of RG-58 Coax Cable

In other words, you can swivel left and right or up and down but not side to side to straighten the antenna to be 90 degrees up and down. This means your vehicle needs either a straight angle on the hatchback or it won't work. On the 2020 Subaru Outback the location I wanted to mount to was either the bottom or the bottom right side. When attached to the bottom there was no way to mount the antenna vertically. When attachec to the bottom right the antenna mount had a similar problem with the antenna pointed about 60 degrees to the right of the vehicle instead of straight up and down. I was able to find a fairly straight edge on the hatcback but it is about 2 feet higher than I was hoping to mount it which means I'll need to fold the antenna down to get in/out of the garage. The main defect of this mount is it lacks the ability to swivel in all 3 axes. With only 2 axes of rotation there are mounting points that will never be practical. I'm going to try the mount out for a few weeks as my only other option that works is a modified bike rack mount that attaches to the trailer hitch but, as expected, that doesn't work great with a hatchback even though I can tilt the trailer mount down but when the dogs are in the back it makes it hard to not have them jump on the antenna or get their leashes tangled up in the antenna so I have to take the mount off which is inconvenient. But if you want to mount your antenna to a standard sedan trunk or engine hood it should work well. Just watch the hatchback mount that you do have a striaght edge to mount to.

Looks like a good mount except I couldn't get it tight enough for the Comet UVH-6 with a few stingers on the antenna.I really like the clam down with soft plastic which keeps the paint from being chipped.

I got 2 of these and mounted them sideways on the top of my cars back hatch. They hold a 38" 140/230/450mhz antenna and a 96" Sirio p5000T 28-30 mhz antenna. I would say get this over a mag mount if you are able. Driven up to 85mph with the antennas mounted and only issue was the "impact fold" of my 3band antenna due to wind load. The mounts are still stable after 2-3 weeks of use.

Works well on my kia sportage......

Using this one on a Kia Sportage hatchback to hold a VHF/UHF antenna for 2-meters and 70-cm.

This antenna mount far exceeds the mount similar to it I had previously. It would never stay tight at the antenna mount, so the antenna kept laying over. This mount has not loosened up at all. The quality of the material is excellent.

Great clamp on antenna Mount. Ready to install. No scratch. Very sturdy .No problems .A little pricy.Recommend buy.

Trying to get a antenna for cb mount

Vernünftiges Teil generell, es gibt aber ein paar Dinge zu beachten:1. Das Kabel ist gedacht für einen PL-Fuss, wer eine Antenne mit DV-Fuss nutzen möchte, welche vom Gefühl her in DE häufiger sind, kann zwar die Klemme immer noch nutzen, braucht aber ein anderes Kabel.2. Die Gummierung verhindert natürlich dass die Montage geerdet ist, das muss man über einen extra Draht ö.ä. an die Karosserie erledigen.3. Diese Umklapp-festzieh-angelegenheit wie beim Fahrrad ist sehr schlecht ausgeführt, der Hebel lässt sich kaum auf dem Bolzen klappen. Dies lässt sich aber lösen indem man den Bolzen durch einen normalen ersetzt, M6 45mm und eine Unterlagsscheibe wäre angemessen.