Burly Brand Easyboy Lite Clutch B17-117

I have a Screamin' Eagle race clutch set at a 145# pull to handle the 130 #s of torque and 130 HP out-put of the Screamin' Eagle 120R engine in my 2006 Dyna Street Bob. The clutch was too hard to pull and I actually hurt my arm after putting 1,000 miles on the original set-up to break in the engine. Burly's Easyboy clutch does what it says. I installed it in minutes and I can now drive my bike knowing my clutch (and my arm) are going to be just fine. The reduction in pull was roughly half of what it was before and although my clutch is still way more than the factory pull, I had no issues putting over 3,000 miles on my bike after the Burly unit was installed.

Great product.

Makes that Harley clutch pull so much easier. Only takes about and hour to install. 100% recommend. Every Harley I have I have installed this product. Best bang for the buck. H-D should come from the factory with this.

Very easy to install way easier to pull heavy duty spring. 1 hour job. Reducing pull weight is a must for us older folks.

For the price, it's worth a try...I'm in the process of changing the handlebar configuration so all cables & lines needed changed out anyway...I gave 4/5 cause I haven't gotten a chance to test it out yet.

I tried to install this on my 09 twin cam and didn't like the fit. I noticed that my cable was rubbing on the cable pass through into the cover. The arm put the cable at a weird angle and I didn't want the cable rubbing like that every time I pulled the clutch. Sitting on the bench now.

The clutch pull is definitely easier, but too easy if you like to shift aggressively. Even with the right tools (snap ring pliers), I had a difficulty with the simple (not easy) install. I'm going to try another solution.

If you would like an easier operating clutch and you are a competent "wrench", this is the kit for you. The hardest part of the installation is getting the exhaust system out of the way. It is inexpensive and works great.