Black 3D Printer Filament ABS 1.75mm

I just built a RepRap Prusa i3 and bought this as my first roll of filament. I don't have a lot of experience with different brands, but I have no complaints about this stuff. I'm through half of my roll and have had no problems caused by the filament. I'll buy from them again.

this came to me very brittle, it has a tendency to break while printing.i have had to load and reload it about 15 times on one roll. i think quality control needs to work a little harder,to mak sure that their product is fresh.

I would say this filament is not the best printing filament but not the worst either.

Fantastic filament, no issues yet! I am about 25% into this, and it works great! The print temperature I use is 235 degrees, although my thermistor might be off. I had one jam that wrecked my nozzle, but I think it may have been a piece that broke off inside the cheap hotend clone I am using. Filament consistency is extremely good as well. I measured .05mm total deviation over 3 meters. The layer adhesion is very good at 235 degrees, not as good at 225 degrees. It is not glossy at 225, but at 235, it is somewhat shiny. I have had very little warping issues with a bed temperature of only 85 degrees. My printbed is a sheet of scanner glass and some nichrome wire. You can use a gluestick to make the part adhere to the bed, and you do not need to buy any tape. Filament is very durable, and comes in a plastic bag with silica gel to keep moisture levels down. I do not have any other ABS filament of my own to compare it to, but the parts off my printer are as strong as my schools $25000 printer. If I had to price this filament, I would have thought that something this good would be $40. I will be buying from them again.