K18 Led Light Bar

I purchased two pair of the 7 inch Led Light Bar, Autofeel LED Pods recently as upgrades for my F250 Super Duty. So far I am very happy with the purchase. The lights arrived on time and well packaged. They are small, but the aluminum housings feel very solid. The clear one piece lens wraps around the front and sides of the light and appears to be sealed very tight. The only place that looks like water could get in is through the rubber grommet where the electrical wires stick out in the back. A dab of silicone should eliminate that possibility. These babies are plenty bright!! After the installation, my wife was following me home from a meeting and I accidentally hit the switch for the rear lights. Once home, she "let me know" that the lights were very bright. The part I can repeat is that she saw spots for ten seconds after the lights were turned off. I intend to use these lights for off- roading and to light up night time construction projects, so I am sure they will provide ample light for my purposes. For my project, I ran a heavy gauge wire from the battery on the passenger side to a small fuse block on the drivers side of the engine compartment. This setup afforded a safer and more accessible location for multiple 12 volt power connections and allowed for a more logical penetration through the firewall for the switch wiring. It also provides multiple in line fuses for circuit protection. Each pair of lights are connected to the power supply through pre-made wiring harnesses also purchased on Amazon. The harnesses are grounded to the chassis, so running a wire to the negative side of the battery is not necessary. I am currently (no pun intended) running a 20 amp fuse from the battery to the fuse block and 10 amp fuses through the harnesses to the lights with no issues, a clear indicator that the lights consume little power. I mounted the front lights on custom brackets in the location where optional factory tow hooks would have been in the event that the new lights were bright. Didn't want to blind other drivers. Good thing I did! The rear lights were hung on some clever brackets available on Amazon that “pinch” the bumper or hood sheet metal. Next I hooked up the harnesses to the lights. The front harness was perfect right out of the box. The rear harness had to be lengthened, but I knew that before the start of the project. Connected the harnesses to the 12 volt power and (angels singing in the background) Bam! Pure white light where once had been nicotine stained light. No more tired eyes from driving at night. It is important that these lights be properly aimed if you plan to use them on the road. Their design features provide for light that illuminates the side of the road as well as further ahead. The light pattern easily exceeds the range of my factory head lights. YouTube has the information needed to aim them properly. I will post an update in the future to attest to their durability. As for now the price, quality, ease of installation, and brightness of the clear white light make me a fan.

These lights are bright an look great at night.. until they don't!! I have a set hooked up to my trucks rear bumper as backup lights, I got a solid 6months out of them, then typical LED issues, yurns out it was corrosion in my factory ground wire, once i cut an replaced that area they function as when first installed, great adjustments, I now highly recommend these to any trailer or alternative backup light. Or a great utility light. Anywhere you need a bright flood light, also they need a minimum of clean 12v to function properly if you only have a few lights an it flickers or is very dim check your power, or in my case the ground/earth connection. These will work with 24v systems too, but any less than 12v not gonna work right. Highly recommend these build quality is amazing these have been submerged many times, smacked around and still work amazing..!

Bought these LED lights for my golf cart. They were easy to install and work great. They also look great and all my friends have commented on them and how nice they look. I also like the side LEDs on both sides of the light to light up on each side of my golf cart. Lights are well made and easy to assemble. Further once installed they can be easily adjusted to wherever you want the light unlikes some other poorly made and none adjustable Chinese made lights. These lights are flood and spot lights which is nice as they throw light out in front and to the sides as well. Seller was also great to work with and I recommend buying from them instead of others who apparently sell the same LED light. Price was also great and a lot lower than other sellers on Amazon. Highly recommended.

Bought these as a cheaper single row to try out having side lights on the rig. They have a much more focused spot beam than I expected, as well as a decent wide angle (simultaneously). I've only had them installed for a week or so, so I will update after some New England exposure. So far I have no complaints!

Purchased a pair of these LED lights to be used as reverse lights to make it easier to hook up my 5th wheel when daylight is limited or non-existent. Easy installation and they did a good job of illumination.....until yesterday I discovered that one of the light fixtures had considerable moisture inside the housing. Seller's statement for these lights: "DURABLE QUALITY LIFESPAN: IP68,Whether it is raining or snow,waterproof IP68 design for all-weather use. Rustproof, dust proof, shockproof and quick cooling aluminum alloy heat sinks effectively extend the lifespan.over 50,000 hours life span" I've sent an email to the seller AutoFeel and asked them to warranty/replace the defective light. As of this time I have had no response from the seller. Hoping AutoFeel will do the right thing. Initial impression of this pair of LED's was very good. Now that I've already had one become defective I'm not so sure I made the right choice. EDIT: I reached out to the seller, AutoFeel and received a response within a couple hours. They requested a photo of the defective light which I provided them. Once they received the photo I received another email stating that they would send me a replacement light. I have now received a set of replacement lights although only one light was defective. At this time I'm very satisfied with the way AutoFeel has handled the issue.

These are really well made, and very bright! They are too bright to be used as fog lights as they blind oncoming drivers, but they are great for dark areas, empty back roads, and trying to find a house in dark neighborhoods. The mounting bracket is sturdy and the light doesn't move after being tightened, even on bumpy roads. The light itself feels very sturdy and so far, I've had no issues with water condensation on the inside, like many of the cheap LEDs get. The beam pattern is interesting: there's one spot pattern facing forward like a normal fog, then there is a flood left and right of that, and flood center, and a very tall flood pattern it lights up the top of tall trees on roads. If driving on the highway where cars are passing in the same direction, they will light up the inside of SUVs/trucks (you can see the drivers head and any passengers as they drive by), and the tops of bridges.

I love how it throws out the lumens. Installed on a 2006 yamaha which was super easy! Wish I bought three of these things - one for each bike. They are super bright! Have had this thing in pouring rain while riding the dirtbike, also loaded into the bed of a truck during pouring rain + 75mph tx speed limits - - no water made it inside! Only caveat - my equipment is cleaned/dried, and stored indoors after its use outdoors. Not sure how this would fair with UV + repeated weather cycles. I would have preferred the wires coming from the light be about 12" instead of the 6" provided. Wasn't quite enough wiring to get it tucked away without the connectors being exposed/accessible. Overall - I'd get more of these in a jifi. Actually, two for each 4 wheeled vehicle, and one for each two wheeled vehicle! *Voltage:12-24V * Wattage: 60W/pair * Material: Die-cast Aluminum housing; PMMA lens * Light Color: White * Color Temperature: 6000K – 6500K * Luminous flux :5500Lm/pair * Lifespan: over 50000 hours * Size: (6.2*1.58*2.16Inch)15.23cm*3.8cm*4.1cm * Beam Pattern: Combo Beam * Mounting Bracket: Stainless stell brackets

Excelente iluminación, fácil instalación!!!