TCHHardware 12 Inch Heavy Duty 250 lb Steel Drawer Slides - 3/4" Wide - Full Extension with Over Travel | Side Mount Ball Bearing Drawer Rails…

These slides are VERY NICE,and cost lots less then most. Much heavier then I thought they would be. Slide very smoothly, nice and heavy. I am use them to make a self to set my small generator on in my box truck. So I can slide it out to put start it and gas in it. Am very pleased with them and recommend them 😊

The media could not be loaded. These slides worked EXCELLENTLY for my project; a DJ Booth Slide Out! The sliding feel is smooth; the weight capacity is more than adequate; and the build quality is EXCELLENT.Now I'm by NO MEANS a carpenter; however, I am now wanting to build some pull out shelving for a cramped pantry in the kitchen.

I made my own drawers for these out of 3/4 ply. I clamped, glued and brad nailed them together. I actually drilled these out for carriage bolts to fit perfectly for mounting. Everything went great! I was able to sit in them with my feet off the ground without any movement. Being an electrician I was both shocked and relieved. They are smooth even loaded down. This was a test run for a future project, so I’m glad they are satisfactory.

Used these along side a set of locking slides for some rear cargo drawers in the back of my GX470. They work well and seem to be holding the weight just fine. Fair warning they do have some “play” in them when drawers loaded so Lee that in mind if you are adding a bunch of weight. They will settle down a bit and in my case they have to be remounted cause the drawers were sagging and dragging on the base plate. Other than that, good slides.

We have these sliders on our overland (off road jeep trailer). They are used to hold the power system of our trailer. (Battery, battery charger, inverter, battery cutoff switch, fuse box, and wires.) These sliders hold up well and support the weight very well. It is nice to have it were we can pull the power system out and check fuses, charger, and all; and then slide it back into the trailer and keep on going. You can take sliders out, but it is a little hard to get them back in. But once they are in, they slide great.

excelente producto.. lo recomiendo..

These were used to support my stereo system (amp, Blue ray, etc) so I could pull it out for service or to change cables. the 36"means I can pull the shelve out far enough to get behind it for easy access. Seems strong and sturdy and easily does the job. Easy to install but you will need your own screws.

I wanted to use the wasted space in the base of my Mill. Was originally going to get the standard 100lb 22" or 24" slides that are pretty cheap, but then I ran across these. I'm at the point in my life where I want things to last, and to be done well the first time, so I splurged. $150 for 3 sets instead of like $30. Then I screwed together scrap melamine I had lying around to make the drawers haha! Until I have time to make metal drawers.The full extension IS WORTH IT. Would buy again for the same project.